ACTIVE UPDATE — ORIGINAL RECORDED TAKES, 18 NOVEMBER 2026 ember, cinder and flare now use user-20261118-recorded3/ loaded-engine/idle takes. The supplied files are the same four recordings listed below. These new takes retain 32 consecutive recorded firings and their individual waveforms; there is no averaging into a single repeated firing. Recorded time is aligned to the firing clock for RPM synchronization; a gain envelope levels recording volume, and the loop join is crossfaded. No EQ is applied to the load recording. The 2.0 TFSI / edition30 audio remains unchanged. Existing limiter, turbo, coast and gear-shift layers remain as previously documented. Earlier update descriptions below are retained as processing history. UPDATE — SMOOTH ENGINE LAYERS, 18 NOVEMBER 2026 Active loaded-engine and idle layers for ember, cinder and flare now use user-20261118-linear2/. Same user-supplied recordings as documented below. Individual recorded firing cycles are aligned and averaged to remove source acceleration/volume envelopes. All load layers use a common phase and playback clock; crossfade energy is normalized using the measured correlation. The 2.0 TFSI / edition30 profile and its audio assets remain unchanged. Limiter, coast, turbo and shift layers retain their current recordings. DJEZ-TUNES — USER-SUPPLIED ENGINE AUDIO, 18 NOVEMBER 2026 Active engine/load, limiter, idle-bed and run-down layers: audio/user-20261118-v1/. Source mapping supplied by the user: 2.0 TDI CR (ember): ssstik.io_1794958982653.mov 1.9 TDI (cinder): v24044gl0000d2caqj7og65o2h3rbng0.mov 2.0 TFSI (edition30): ssstik.io_1794958703911.mov 1.8T (flare): v12044gd0000d4i5c3nog65in4epr6i0.mp4 Processing: audio extraction to mono PCM 32 kHz; DC/low-rumble cleanup; pitch-stabilized load grains, overlapping loop joins and matched loudness. RPM anchors are adapted to the game's fictional engine ranges, not measured telemetry. Limiter layers use the end-of-pull portions of the supplied recordings. Idle beds are derived from the lowest available loaded segment; these clips do not provide separate idle recordings. For clips without a complete run-down, the run-down is derived from their own upper-RPM layer with a falling playback rate. The shared player uses these engine layers for dyno, free road and online 400 m. Previously selected turbo, dump, exhaust-pop and ED30 gear-shift layers remain separate effects, with their existing sources documented below. No original video is served by the game. No public licence is asserted by this file. ARCHIVE / SOURCES OF RETAINED EFFECTS AND OLDER UNUSED ENGINE LAYERS DJEZ-TUNES — REFERENCES AUDIO V2 Sons adaptés depuis les trois vidéos de référence demandées pour le projet : 1.9 TDI : Polo 1.9 TDI 130, passage au banc. Auteur / chaîne : JACK LARNAQUE PERFORMANCE. https://www.youtube.com/shorts/IdENGkItxJc Extraits moteur et hardcut enregistré. 2.0 TDI CR : Audi A3 Quattro 8P 2.0 TDI CR170, dyno / popcorn limiter. Auteur / chaîne : R26. https://www.youtube.com/watch?v=URGVmKoTTbc Extraits moteur et hardcut enregistré. 1.8T : MMP Audi A4 1.8T on the dyno. Auteur / chaîne : momentummotorparts / Momentum Motor Parts. https://www.youtube.com/watch?v=M3mgONtsRTQ Extraits du moteur en charge. Le rupteur est reconstitué par coupures de cet extrait : ce n'est pas une prise de son distincte d'un rupteur de la vidéo. Adaptations : extraits courts, mono, filtrage des bruits de banc, bouclage avec fondus, normalisation et adaptation au régime simulé. Les repères de régime suivent les fréquences de combustion enregistrées, mises à l'échelle de la simulation fictive ; aucune télémétrie du véhicule filmé n'est disponible. Chaque moteur utilise sa propre couche turbo extraite de sa vidéo. Le maintien au rupteur dure 0,8 seconde de temps réel, même en mode rapide. Les vidéos et leurs auteurs ne sont pas associés au simulateur. Les extraits ne sont pas présentés comme étant sous licence Creative Commons ; aucune licence libre n'est indiquée dans les métadonnées de ces trois vidéos. Crépitements additionnels : prise de son Car Antilag par modusmogulus (CC0). https://freesound.org/people/modusmogulus/sounds/797835/ https://creativecommons.org/publicdomain/zero/1.0/ --- ARCHIVES AUDIO V1, FICHIERS NON UTILISES PAR LES PROFILS V2 --- # Djez-Tunes — enregistrements audio Les voix moteur proviennent de prises de son réelles, découpées en boucles, filtrées, égalisées, normalisées et adaptées au régime de la simulation. Les repères de régime des boucles sont des réglages de lecture : la source ne fournit pas de télémétrie synchronisée. Les coupures au rupteur sont reconstituées en coupant ces boucles selon l'état du moteur simulé ; il ne s'agit pas de prises de son séparées de hardcuts sur ces voitures. ## 2.0 TDI CR — Ember Soundholder / Dawid Moroz, « audi a4 b8 20tdi update engine set2 start idle gas pressing off mono.wav ». Source : https://freesound.org/people/Soundholder/sounds/425394/ Licence : CC BY 3.0 — https://creativecommons.org/licenses/by/3.0/ Adaptation : extraits, filtrage, montage de boucles et normalisation. Fichiers : cr-low.wav, cr-mid.wav, cr-high.wav. ## 1.9 TDI — Cinder Evilmikie, « vw diesel engine.mp3 », enregistrement de son VW New Beetle TDI. Source : https://freesound.org/people/Evilmikie/sounds/448217/ Licence : CC0 1.0 — https://creativecommons.org/publicdomain/zero/1.0/ La famille 1.9 TDI est déduite du modèle New Beetle ; l'année et la variante d'injection de la voiture enregistrée ne sont pas précisées par l'auteur. Référence du modèle : https://www.volkswagen-newsroom.com/en/engine-versions-new-beetle-profile-19555 Adaptation : extraits, filtrage, montage de boucles et normalisation. Fichiers : tdi-low.wav, tdi-mid.wav, tdi-high.wav. ## 1.8T — Flare et couche turbo fredless, « audiwhistle.mp3 », Audi A4 2002 1.8T, accélération en troisième. Source : https://freesound.org/people/fredless/sounds/181165/ Licence : CC0 1.0 — https://creativecommons.org/publicdomain/zero/1.0/ Adaptation : extraits, réduction des graves parasites, boucles et normalisation. La couche turbo commune est un extrait filtré de cette prise de son. Fichiers : 18t-low.wav, 18t-mid.wav, 18t-high.wav, turbo.wav. ## Crépitements d'échappement modusmogulus, « Car Antilag (No cleanup, 32float) », prise de son réelle. Source : https://freesound.org/people/modusmogulus/sounds/797835/ Licence : CC0 1.0 — https://creativecommons.org/publicdomain/zero/1.0/ Adaptation : un transitoire extrait, filtré et normalisé. Le véhicule n'est pas identifié comme un 1.8T ; il sert de couche d'effet d'échappement. Fichier : exhaust-pop.wav. Ces auteurs n'ont aucun lien avec Djez Performances et ne cautionnent pas le site. GOLF 5 GTI EDITION 30 — added November 2026 Source: MotorsportCheck, VW Golf 5 GTI Edition 30 sound acceleration 0-100 EDI test https://www.youtube.com/watch?v=HfHRQyOtwOQ Short engine grains at 25–29 and 55–57 seconds, filtered and looped. RPM anchors are scaled playback references, not measured telemetry. Turbo layer is filtered from the same recording. Limiter is reconstituted by gating the loaded engine recording, not an isolated recording of its limiter. Pops use the existing recorded exhaust-pop transient credited above. No free licence was declared in the video metadata; authors retain rights and are not affiliated with the simulator. STUDIO — PHASE LAYERS Idle/overrun/turbo-release layers are short filtered extracts from the same four video references credited above. No additional vehicle recording or synthetic engine oscillator is substituted. 1.9 TDI idle: an adapted low-RPM firing grain from the reference, slowed to the simulated idle cadence (the video does not contain an isolated idle recording). 2.0 CR idle: short steady tail near 25.25 s; 1.8T idle: steady falling tail near 34.8 s; Edition 30 idle: steady idle near 7.45 s. All idle cadences are adapted for the game. Overrun clips: 1.9 TDI 13.45 s, 2.0 CR 24.05 s, 1.8T 17 s, Edition 30 45.2 s. Petrol turbo-release clips are filtered from the same recordings near 17.45 s / 57.55 s. Pitch references remain playback anchors, not measured telemetry. The original engine/limiter banks are preserved; the limiter hold remains 0.8 s. 1.8T TIMING CORRECTION — November 2026 The final sweep grain overlapping the reference limiter was removed. references-v3/flare-limiter-synced.wav uses a phase-aligned loaded-engine grain near 15.5 s of the same Momentum Motor Parts source, filtered 40–8200 Hz and normalized. The simulation gates this carrier only during its limiter phase. No additional source or synthetic motor oscillator. ED30 NEW USER REFERENCE —17 November2026 Source: West Yorkshire Tuning WYT, Seat Leon FR 2.0 TFSI 200BHP - Custom Dyno Tuning + Decat Software https://www.youtube.com/watch?v=iEBG5S3JrS4 User confirmed starting at0:16. Engine grains16.1–23.5s; clean loaded limiter carrier near23.3s gated by simulated ignition cuts; filtered turbo21.2s; adapted idle16s; overrun24.2s; release24.35s. RPM anchors are scaled playback references, not telemetry. This source is a Seat Leon recording chosen by the user for the fictional GILF5; it is not claimed to be a recording of an Edition30. No free licence declared in video metadata; authors retain rights and are not affiliated with Djez-Tunes. ED30 DSG GEAR SHIFT —17 November2026 User source: DASDAVID, MK5 GTI Mufflers delete ,DSG fart https://www.youtube.com/shorts/SSbhClzIby4 Adaptation: short filtered shift transient at4.90–5.36s, centred on the requested5-second event, normalized with a short fade. Played only on an actual upshift under throttle in road mode. Not a synthetic pop. No free licence declared; original author retains rights and is not affiliated with the simulator. ROAD SHIFT CONTINUITY —17 November2026 The unloaded spinning-engine bed remains audible during the simulated torque interruption, with smoothed gain and pitch. The actual drivetrain torque cut and all dyno exercises remain unchanged. The ED30 DSG extract is now the user-selected five-second event, with an8ms attack and65ms release. REALISM MIX —17 November2026 Existing user-selected recordings retained, including the5-second ED30 DSG extract. Engine load and idle pitch are continuous; fitted intake/exhaust parts alter filtering and relative gain. Turbo pitch follows simulated pressure and engine speed with smoothing. No new source and no synthesized engine voice. Numerical filters are an adaptation, not an acoustic measurement of each fitted component. DRAG / ROAD AUDIO REFINEMENT — 17 November 2026 The same four user-selected recordings are retained. road-v4 uses longer, pitch-stabilized recorded grains, a short cyclic seam correction, DC removal, high/low-pass filtering and matched RMS. Grain pitch is stabilized by resampling against the previously estimated sweep cadence; these anchors remain approximations, not vehicle measurements. Recorded TDI hardcuts and the selected 5-second TFSI DSG transient are retained. Idle beds are cleaned adaptations of the existing recordings. Engine load follows torque when the network race curve omits fuel data; gentler master compression, restrained turbo gain, continuous unloaded engine and rapid attack/release reduce abrupt changes. No synthetic engine oscillator and no new external recording.